空调移机步骤 |
添加时间:2018/3/12 15:51:18 浏览次数:10 |
1.确定空调移动的位置,管度的长度是否足够。空调的安放位置是否适合,是否符合各种要求等。空调的重新移机也是需要符合一般安装空调位置的要求的。应该勘察好环境位置是否适合转移空调,再准备好需要的材料和器材。包括制冷修理工具一套,以及室内外机的固定用膨胀螺丝等材料。还有需要更新、延长等的管道等等。
1. determine the position of the air conditioning, the length of the tube is sufficient. Whether the placement of air conditioning is suitable, whether it meets the requirements and so on. The new machine air conditioning also need to meet the general requirements of the location of the installation of air conditioning. It is necessary to find out whether the environment is suitable for the transfer of air conditioning, and to prepare the materials and equipment needed. It includes a set of refrigeration repair tools and a fixed expansion screw for indoor and outdoor machines. There are also pipes that need to be updated, extended and so on.
2.回收制冷剂:把空调器中的制冷剂收集到室外机中去。拆机前应启动空凋器,可用遥控器设定制冷状态,待压缩机运转5-10分钟,制冷状态正常后,用扳手拧下外机的液体管与气体管接口上的保帽,关闭高压管(细)的截止阀门,l分钟后管外表结露,立即关闭低压管(粗)截止阀门,同的迅速关机,拔下电源插头,用扳手拧紧保险帽,至此回收制冷剂工作完成。也可采用室内机上的强制启动按钮开机,同的观察室内、外机是否还有其他故障。避免移机后带来麻烦。
2.: the recovery of refrigerant refrigerant in air conditioner outdoor unit to collect. Before start the air conditioner to disassemble, use the remote control to set the cooling condition, the compressor to run for 5-10 minutes, cooling state is normal, with the wrench under the machine liquid tube protective cap on the interface with the gas pipe, close the high-pressure tube (fine) cut-off valve, l minutes after the tube surface condensation, close the low pressure tube immediately (coarse) cut-off valve, with rapid shutdown, unplug the power plug, use a wrench to tighten safety cap, thus recovering refrigerant work. It can also use the forced start button on the indoor machine, and whether there are other faults in the same observation room and the outside machine. After moving to avoid trouble. |
上一页 如何拆空调 空调移机 |
下一页 空调移机步骤 |